I couldn't wait so I started hacking and sawing my plumbing tonight.
I will admit I thought it was going to be a breeze to setup, but took me longer than I thought all because I didn't push the connector in far enough
Plumbing it was simple, that took maybe 10 minutes. For the life of me I couldn't get the port on the module to recognize it was a flow sensor, seemed autodetect wasn't working.
I upgraded the firmware on the module, tried all other 3 ports - same thing, wouldn't recognize in classic dashboard so obviously nothing shows up in Fusion dashboard
A few back and forth with support we finally figured it out. You have to REALLY push the connector into the module for it to recognize, I mean push so hard it popped off the wall hard. Once we found that, it auto recognized and I'm watching the flow now.
Interesting fact, I bought my DC10000 new a few years ago. It is supposed to run at 10000 lph. I can now tell you that at full speed my pump is running at 2858 lph. Before you think I've confused gallons for litres, I haven't
Not sure
Sent from my BBA100-1 using Tapatalk
