Apex - IOAT pump programming

[Kyle1970]

I’m trying to program my Sicce pump through Fusion.
I have control and have programmed the different cycles through the Fusion app.

I want to program for 2 things.
1. Feed cycle to ramp down to 1 or 2%
2. Pump shutdown if my leak sensor circuit closes.

Do I program the Sicce pump or program the outlet?
They show separated in the tiles.

Each time I’ve tried a simple IF closed then off line the Sicce pump will not come back online without uninstall and reinstall.

Anyone else have some direction that would help?

 

[TORX]

Start with this at the 29:00 marker. Takes about the task at 35.00. Then you program the Feed mode through the Sicce program, not the outlet. They have samples at 40.00

Personally i do not like IOTA. For it to work properly then the pump needs to get a signal from the Apex to change. If it does not get that signal whether the power went out or signal was interrupted then the pump, lighting or equipment will not change until the next program is sent.

 

[Kyle1970]

It does seem a bit unreliable.
But perhaps due to me not following along with the programming.

I’ll check the video. Thanks @TORX

 

[Kyle1970]

Got it working.
Will see how the programming holds up.