Cliff
Active Member
- Joined
- Dec 11, 2014
- Location
- Canfield, Ontario
So I have set up my breakout box on my apex; but I would like to name each switch. is that possible? Right now they just say SW1 SW2 and so on is it possible to name those switches?
Labeling Apex I/o Switches In Fusion?
- Thread starter Cliff
- Start date
Cliff
Active Member
- Joined
- Dec 11, 2014
- Location
- Canfield, Ontario
Can it be done thru apex?
I don't think it can be done in fusion, I could be wrong.
Type "apex/nstatus.sht" in the address bar and you should get the old apex
With current firmware, you can update it through the Apex via the webpages as noted above. It can not be done through Fusion yet. You have to log into your Apex the old way on a computer and go to Configuration -> Probe/Input Setup. Select the input and you can change the name.