Nemo22
New Member
Anybody know a fix I can try or is the module burnt out?
I have a spare mp40, could I use that controller to run MP10?
Used these units for many years and I never had an issue
I would contact their customer support team directly - they are very responsive
Are the lights on the module flashing? When I had problems with the ones I used to have the lights would flash indicating a diagnostic trouble code.
It is probably a bad power pack. It would shut off to protect the driver itself. You should be able to find a replacement. Is it getting really hot before shutting off? Before you buy a replacement do you have another that you can test on the driver? If it still does it you know it is the driver and if not it is the power source itself.
They will probably ask you do try a hard reset...may as well give it a go.
YES TORX, I think the change out of the power pack along with the hard reset has done it. Been watching it for only 15mins since reset but usually it would power off in less than 2 mins.