Thoughts On A. I. Prime Led - Settings

[Aquatic Dreams]

So as mentioned in another thread I picked up a 29g Biocube with an AI Prime LED light.

http://www.thefragtank.ca/community/threads/29-gallon-biocube-suggestions.18284/

I'm really liking the light so far and there are a ton of various settings and features. However I am getting a bit of rainbow-ness on the sand bed from slight water turbulence at the top. I currently have mine set fairly low as I don't want to shock new corals that I put in.

Just wondering what those of you who also own this light think of it, what settings you have yours at and what features you use. Any tips or tricks to using this light?

This is a pic of the light ramping up from being off ...




Please share any thoughts, settings and pics that you may have!

Dave.

 

[Aquatic Dreams]

Nobody else here uses the AI Prime?

 

[TORX]

The rainbow is typical of a lot of LED lights. Most people keep the reds way down as they tend to stand out the most. Plus they promote algae.

Sent from my SM-G925W8 using Tapatalk

 

[Aquatic Dreams]

I had heard that about the reds. The highest my red gets is 8% at the moment. The light looks good but still seems like it needs some tweaking. I was just hoping that others on this forum were using these lights as well and could share some values. The one I have is currently sitting appox. 7" above the water.