So, with shows popping up faster than dandelions, I looked into making something to speed up the packing up for the shows.
Since you are bringing a pail(s) of water with you, it made sense to make it fit in the bucket. Two birds one stone if you will.
Added some legs to make it stackable, a hole in the middle to lift the rack out of the bucket by (an over sight on the proto type!) and some wedges to keep the disc tight in the pail.
End result;
I should have the finished product back from the cutter this week. I have a version that holds a piece of egg crate. 6 of these pieces of eggcrate will fit in the frag swap tank I make.
Since you are bringing a pail(s) of water with you, it made sense to make it fit in the bucket. Two birds one stone if you will.
Added some legs to make it stackable, a hole in the middle to lift the rack out of the bucket by (an over sight on the proto type!) and some wedges to keep the disc tight in the pail.
End result;
![Frag-disc-proto-type-e1374378746954.jpg](http://jtcustomacrylics.com/wp-content/uploads/2013/07/Frag-disc-proto-type-e1374378746954.jpg)
I should have the finished product back from the cutter this week. I have a version that holds a piece of egg crate. 6 of these pieces of eggcrate will fit in the frag swap tank I make.