Tank Cleaning

jeffopentax

Super Active Member
Joined
Nov 11, 2013
Location
Brantford, Ontario
Found this on the Stendker Discus site, but figured it could to be useful for anyone starting up a tank.


Cleaning a new aquarium

When you clean a new aquarium for the first time, you should use a vinegar solution, diluted with water. Wash the insides of the glass panes and the silicon joins thoroughly with the vinegar solution. Then wipe everything dry, so that no chemical residues remain, which could affect your water quality.

Cleaning a used aquarium

Disinfect used aquariums with hydrogen peroxide (available from chemists or drug stores). Dosage of the hydrogen peroxide solution:
Use 0.5 litres / 0,13 US gallons of a 30 % hydrogen peroxide solution per 180 litres / 50 US gallons of water. Fill your aquarium with water and add the required dosage of the hydrogen peroxide solution as described above. This will disinfect the contents of the aquarium, the filters, any nets and also the water itself. Allow this water and hydrogen peroxide solution to stand for a full 24 hours. Then perform a 99% water change and fill the aquarium with fresh tap water. By using this procedure, you will kill off all bacteria and remove any germs/ pathogens.


Sent from my iPhone using Tapatalk
 

jeffopentax

Super Active Member
Joined
Nov 11, 2013
Location
Brantford, Ontario
I think the wife would be more than a little pissed if I used vinegar with the tank being in the living room!


Sent from my iPhone using Tapatalk
 

heath

Distinguished Member
Joined
Oct 2, 2012
Location
Woodstock, Ontario
it isn't too bad, your room will smell like a French fry, I have never let it sit in the tank,, doesn't take that long to clean it and the smell goes away fairly quickly..
 

jeffopentax

Super Active Member
Joined
Nov 11, 2013
Location
Brantford, Ontario
it isn't too bad, your room will smell like a French fry, I have never let it sit in the tank,, doesn't take that long to clean it and the smell goes away fairly quickly..
I 'm doing the full 24hr hydrogen peroxide. Not taking any chances!


Sent from my iPhone using Tapatalk
 

jeffopentax

Super Active Member
Joined
Nov 11, 2013
Location
Brantford, Ontario
This question kinda fits here. I'm going to use a shop vac to get the old sand out of my tank. It is currently still full of water. Should i drain then vacuum out sand, or vacuum out sand/water at the same time?


Sent from my iPhone using Tapatalk
 

reef keeper

Super Active Member
Joined
Nov 19, 2014
Location
Hamilton, Ontario
I figu
That's what it came to?! You don't f*ck around!


Sent from my iPhone using Tapatalk
I figure it's gotta be close!!

Drain the water first. Then scoop out as much of the sand as you can into buckets. Moving A shop vac full of water and sand is a train wreck, nightmare and inevitable divorce.

Stay thirsty my friends
 

jeffopentax

Super Active Member
Joined
Nov 11, 2013
Location
Brantford, Ontario
I figu

I figure it's gotta be close!!

Drain the water first. Then scoop out as much of the sand as you can into buckets. Moving A shop vac full of water and sand is a train wreck, nightmare and inevitable divorce.

Stay thirsty my friends
I've used a shop vac to remove sand before. The only problem i had was having to unclog the hose 3 or 4 times. If i left at least a bit of water maybe it would prevent/reduce clogging? I don't know since last time I drained all the water first. Maybe it doesn't make a difference. Moving it is easy since it has wheels.


Sent from my iPhone using Tapatalk
 

jeffopentax

Super Active Member
Joined
Nov 11, 2013
Location
Brantford, Ontario
I'm just sayin.... I used a dust pan to remove my sand after siphoning most of the water out. Then shop vaccd out the rest of the water.
I get what you're saying. I actually make a bigger mess scooping. With a vacuum it goes straight from tank, to vacuum, to outside :)


Sent from my iPhone using Tapatalk
 
Top