mmckaig
New Member
- Joined
- Jan 14, 2013
- Location
- Conestogo, Ontario
I would like to setup some code to tell my system to shut off the RO ATO and run a SW ATO when the cond probe is at a set number.
I appreciate that there is a lot of danger in this since the probe isnt perfect BUT, I travel a lot and I am OK with automation... Besides, who doesn't look at the fusion panel on their phone at least 3 times a day... I can watch the cond numbers and go back to RO ATO any time.
I have set of switches in my sump as well a DOS doing water changes.... I have double checked the calibration of dos and it is spot on so, I am not 100% sure where the issues are, regardless, topping off with salt seems to be the right thing for me to do.
Anyone else doing this and have some sample code?
MAtt
I appreciate that there is a lot of danger in this since the probe isnt perfect BUT, I travel a lot and I am OK with automation... Besides, who doesn't look at the fusion panel on their phone at least 3 times a day... I can watch the cond numbers and go back to RO ATO any time.
I have set of switches in my sump as well a DOS doing water changes.... I have double checked the calibration of dos and it is spot on so, I am not 100% sure where the issues are, regardless, topping off with salt seems to be the right thing for me to do.
Anyone else doing this and have some sample code?
MAtt